Smart Self-Priming Pump with Flow Sensor and Pressure Sensor

Pump
>> Pump Body: Cast iron with special anti-rust treatment
>> Impeller: Stainless steel, Brass, or PPO
>> Mechanical Seal: Carbon / Ceramic / Stainless Steel

Motor
>> Integrated thermal protector for single-phase motor
>> Motor with copper winding
>> Motor Housing: Steel plate or Aluminum alloy
>> C&U bearing
>> AISI 304 shaft or 45# carbon steel

Working Range
>> Liquid: Clean liquids without suspended solids, non-aggressive
>> Liquid temperature: -10°C to +100°C
>> Ambient temperature up to +40°C
>> Max. working pressure 10 bar
>> Continuous service S1
>> Insulation: B
>> Protection: IP44

Application
>> Household Water Supply
>> Water Supply System
>> Cooling System
>> Boost System

Advantages
>> Electronic pressure switch controlled by PC clip to avoid frequent pressure switch activation.
>> Every 72 hours, it starts for 10 seconds to prevent pump lock when not in use.
>> Water protection system to avoid prolonged dry running of the pump.
>> 3-second delay before starting to avoid electrical sparks and protect personal safety.
>> Flow priority system ensures full pressure operation.

KJ-A SERIES INTELLIGENT WATER PUMPS ------FOR COLD AND HOT WATER
1. Self-priming: Fill the entire pump chamber with water before first use.
2. Automatic: Powered on/off by automatic system—turn on the tap and the pump works, turn off the tap and the pump stops.
3. Booster: Stable and powerful pressure is controlled by pressure and flow sensors.
Additionally, a thermal protector in the motor interrupts current if the motor overheats.




                                                                     



FAQ

Ethylene Cracking Furnace Anchor

Anchors are mostly used as fixtures for integral linings (castable, plastic and sprayable linings). Refractory brick linings also use anchors, but they are not used in many occasions. Metal anchors are usually used to support and fix thin or heat-insulating integral linings, such as chimney linings, wear-resistant linings of petrochemical catalytic cracking reactors (usually tortoise shell mesh anchors), integral jet metallurgy The lining of the spray gun, the overall lining of the immersion pipe of the DH and RH vacuum degassing devices, the lining of the rotary kiln discharge day, the feeding port, etc. Metal anchors are mostly used to fix linings with a long-term use temperature below 1200 °C, or short-term use temperature above 1200 °C that can be used intermittently. Ceramic anchors are usually used to fix thicker (greater than 200mm) integral linings and are characterized by:
(1) It can withstand higher operating temperatures, and is generally used in the lining of kilns that are used for a long time above 1200 °C;
(2) It can withstand the erosion and corrosion of corrosive atmosphere;
(3) It can be extended to the working surface to reduce the peeling of the overall lining;
(4) Compared with metal anchors, the contact area with the refractory lining is large, so it has a greater supporting capacity;
(5) The thermal expansion coefficient is equivalent to that of the overall refractory material, which can eliminate the cracking or peeling of the lining due to thermal expansion mismatch

Ethylene Cracking Furnace Anchor,Corbel Anchor,601 Inconel Refractory Anchor,310 Stainless Steel Refractory Anchor

Puyu kiln technology (jiangsu) CO.,LTD , https://www.anchorpy.com